working metal blades
Submitted by sammytheshark on Mon, 2010-12-06 12:34
Hi all,
I just got a metal blade for free of a mate but im not one hundred % shore on how to work them.
If you have a good idea of using them please let me know in the chat below...
Thanks sam
Lamby
Posts: 3145
Date Joined: 04/08/09
Step 1) Demand wallet Step
Step 1) Demand wallet
Step 2) Brandish metal blade
Step 3) All in the technique short sharp jerks and wave menacingly, I like to mix it up
Leemo
Posts: 3712
Date Joined: 22/02/07
my personal favourite is the
my personal favourite is the old 'stabby mc-rip stab stab'!
bludgin' since 94'
PattyT
Posts: 1025
Date Joined: 15/08/10
haha.. well played!
haha.. well played!
shifeng
Posts: 236
Date Joined: 22/09/09
just throw it at the target!
just throw it at the target! but practice first.
carnarvonite
Posts: 8673
Date Joined: 24/07/07
Blades
The only blades to buy are from Victrinox or Swibo and they don't throw too well.
skrewloose
Posts: 335
Date Joined: 27/08/09
i'll help ya for bream i
i'll help ya
for bream i like to cast it close to the structure pillons are the easiest with blades with the line on the back hole and just slowly lift and wind and make sure its slowly and my Favorite trick is to keep the line tight on the drop as this is were i get most of my takes
lox ambassador
aussie_breamer
Posts: 359
Date Joined: 24/08/10
bream
I like to flick it close to structure, then let it sink, then work it back slow lifts of your rod tip then let it sink again. but always have pressure on the line even on the drop to fell when a bream picks it up.
bream slayer
rainbow
Posts: 250
Date Joined: 03/01/08
might be a silly question but
I tried out a ghost blade for the first time last night & the bottom treble kept catching on the swivel snap that i used to join the lure to the line. I used the middle hole. Should the line be joined direct to the quick snap clip to avoid this?