ok boilys i have a question
Submitted by petermac on Mon, 2018-06-04 19:10
i managed to coil the end of my No 5 saccra anchour i got it straightened out by a local bloke but he used heat went out this weekend and same thing the tip coiled over , i straightened it out with a big shifter and vice (no heat ) , how do i get the hardness back in the anchour tip
Jackfrost80
Posts: 8140
Date Joined: 07/05/12
Triple jab should do the
Triple jab should do the trick
Officially off the Pies bandwagon
piston broke
Posts: 776
Date Joined: 05/11/08
come
on Jack
biggerfish
Posts: 669
Date Joined: 02/03/09
Fill with sand and cap the
Fill with sand and cap the end
Play hard fish harder
Vinesh87
Posts: 2751
Date Joined: 02/04/11
Pete why are you running a
Pete why are you running a Sarca 5? Theyre rated for like 5T boats hahhaha
sea-kem
Posts: 14960
Date Joined: 30/11/09
What is it made from?
What is it made from? Stainless or galv mild steel?
Edit: Have just read a blurb on them and are galved mild steel. So in essence you can't harden it without rooting the galv. To bending it like you say sounds like you're doing it all wrong lol. If you keep bending it you will eventually snap it off as galv makes it brittle.
Love the West!
Saulty2
Posts: 655
Date Joined: 28/05/10
need special steel
you cant harden mild steel that has been galvanized
marble
Posts: 775
Date Joined: 03/09/09
I want to know how your
I want to know how your bending it in the first place ?
PMY 25 Centre Console DF300 Suzuki
Scotte
Posts: 1145
Date Joined: 07/12/06
The tip hits a bit of hard
The tip hits a bit of hard bottom and rolls over.happens all the time.
Anchor still works fine even with the rolled over edge
woody
Posts: 617
Date Joined: 27/02/08
Paint it blue and
Paint it blue and yellow....that will make it harder and it will never let you down again.
sea-kem
Posts: 14960
Date Joined: 30/11/09
Ha ha Paid
Ha ha Paid
Love the West!
timboon
Posts: 2954
Date Joined: 14/11/10
Get your hand off it Woody,
Get your hand off it Woody, that was rank....
bradz
Posts: 693
Date Joined: 29/10/07
Bent
Pete
Ive just bought a new sarca and there is already a slight bend in the tip. Probably the last 30mm. Perhaps you dont need to bend it back anyway as I think its part of the design.
I did then the best that I knew how. When I knew better, I did better.
upg
Posts: 137
Date Joined: 25/06/07
The tip isn't stiff enough.
The tip isn't stiff enough. Design flaw I reckon. I'd get the bottom plated up like a delta
Redfinman
Posts: 80
Date Joined: 18/10/09
Any metal that has been hot
Any metal that has been hot dipped galvanised is always soft. Only dua plate or medium carbon steel that has been hardened and tempered will handle what you expect it to do but it will always be open to the salt effect and corosion.